inginition cylinder again

Charging, starting, lighting, gauges, HVAC

Moderators: FORDification, Thunderfoot

Post Reply
User avatar
cathynkeith
Preferred User
Preferred User
Posts: 420
Joined: Tue Aug 15, 2006 9:18 pm
Location: Texas, Longview

inginition cylinder again

Post by cathynkeith »

Ok I'm dumb, I got it out, now how does it go back in? I lined up insides, done every thing I can think of (accept throw it across the room) :dk:
P.S. This is the key cylinder back into ing. swich I'm talking about.


http://s115.photobucket.com/albums/n292 ... type=local
http://s115.photobucket.com/albums/n292 ... type=local
Life is good...... when nothing is wrong that money can't fix.
1969 f100 flareside
1962 ECONOLINE TRUCK (done)
1975 Nova (almost done)
fordman
100% FORDified!
100% FORDified!
Posts: 22329
Joined: Sun Aug 28, 2005 8:17 pm
Location: Kansas, Ottawa
Contact:

Post by fordman »

the shiny pin holder goes up and i think you have to start in the acc postion. thats the way it comes out.
User avatar
hardtailjohn
Preferred User
Preferred User
Posts: 422
Joined: Tue Dec 07, 2004 10:24 pm
Location: Montana, Marion

Post by hardtailjohn »

Sounds right to me, and I also left the piece of safety wire in the hole above the key until I had it in there...
JH
Never trust a grinning idiot holding a big hammer!
User avatar
cathynkeith
Preferred User
Preferred User
Posts: 420
Joined: Tue Aug 15, 2006 9:18 pm
Location: Texas, Longview

Post by cathynkeith »

so its kinda like my wife, gota push the right button to get it in :)
thank you.
http://s115.photobucket.com/albums/n292 ... type=local
Life is good...... when nothing is wrong that money can't fix.
1969 f100 flareside
1962 ECONOLINE TRUCK (done)
1975 Nova (almost done)
User avatar
jzjames
100% FORDified!
100% FORDified!
Posts: 1776
Joined: Sun Jan 09, 2005 2:59 pm
Location: Washington, Windy Point

Post by jzjames »

*"To install: insert a screwdriver into the lock opening of the switch and turn the slot in the switch to the full counterclockwise position."
???
Chilton Pickups 1965-86
p.282
kid

Post by kid »

Yep full counter clockwise and if you removed the key from the lock you have to insert the key and wire and rotate the tumblers to the same full clockwise position. Then stick it in.
Post Reply