FORDification.com
   (powered by Google)


  HOME

  Technical Articles

  Factory Literature

  Discussion Forums

  Photo Galleries

  The BumpWiki

  Service Bulletins (TSBs)

  Decoding Your VIN

  Diagrams & Schematics

  Links & Resources

  In the Movies

  Downloads
  Member Meet & Greets

  In the Media

  Site Index

 MISC / PERSONAL

  My Truck Projects

  My Heinz 57 '67

  I've Been Censored!

  Contact


You are here: Home Tech Articles & Tutorials Steering / Suspension / Brakes
Back to Technical Index
Technical Articles - Steering / Suspension / Brakes
How to Install Power Steering in 2WD '67-'72 Ford Pickups
     A complete tutorial on what parts you'll need and where to get them

Integral Power Steering for '67-'77 4WD Highboys
     How to mount a 2WD Saginaw PS box for use in your 4WD

Adding Power Steering to an F-100 4x4
     (under construction)

Ford/Thompson Power Steering Pump Diagnosis & Testing
     A 1969 factory technician's troubleshooting book in PDF format (28MB)

How to Install a Tilt Steering Column in a '67-'72 Ford Pickup
    
(under construction)

How to Shorten Your Manual-Steering Column
     A companion tutorial to the power steering tutorial above

The Manual 3-spd Steering Column Explored
     A collection of photos taken while disassembling several 3-spd columns

Shortening a 3-spd Manual-shift Steering Column
     How to properly mate a 3-spd column to a Saginaw PS box

Installing Front Disc Brakes on Your 2WD Pickup
     It's a lot easier than you might think...

Comparing '67-'79 I-beams and Spindles
     A companion guide to the disc brake tutorial above. Read this before starting your conversion!

Steering/Suspension Component Variations
     Comparison photos of some differences in parts you should be aware of

'65-'79 Ford Pickup Suspension Lowering Basics
     Some good basic information on how to lower your Twin I-beam truck and what parts are needed

Proportioning Valve 101
     A quick photo-tutorial describing the differences of some key brake components, namely the brake pressure
       differential valve, the metering valve and the proportioning valve.

How to Properly Double-Flare Brake Lines
     A quick photo-tutorial from my own project pages, helpful when fabricating replacement brake lines

Comparing Clutch/Brake Pedals and Brackets
     A photo tutorial about 'what fits what' in regards to brake pedals and pedal pivot brackets

Installing a Hydroboost Brake Setup
     A tutorial describing the installation of a factory Hydroboost setup on an early Bronco

Remanufacturing Disc Brake Spindles
     A photo tutorial showing how one forum member machined his spindles and custom-made his own kingpin bushings

Front Wheel Alignment Specifications

Ford Truck/Van Hubcap Identification and Interchange
     A guide to identifying factory pickup hubcaps

 

 
You are here: Home Tech Articles & Tutorials Steering / Suspension / Brakes


Want to link to this site? Please save this banner to your hard drive to place on your webpage.
The correct link to use is http://www.fordification.com

Copyright 1999-2016 FORDification.com unless otherwise noted. All rights reserved.
All brand names and product names used on this website are trade names, service marks or registered trademarks of their respective holders.  
No portion or content of this site may be reproduced or otherwise used without explicit permission.
To report problems or provide comments or suggestions, please click here.